🚀 go-pugleaf

In article <1407@ncar.ucar.edu> cook@stout.UCAR.EDU (Forrest Cook) writes:

>
>I have an old Imsai and the reason your bus has non-square waves is probably
>due to the fact that the front panel's LEDs are connected directly to the
>bus with NO buffering.  Who did that anyway?  If you want to make the thing
>work much more reliably,  kludge in some octal buffer chips between the
>bus and the LEDs.  While you are at it, it might not hurt to cut the power
>switch traces that run about 1/4" from a bunch of one-shots and run the AC
>right to the switch.  220/330 ohm terminator resistors on all of the bus
>lines will also clean up the signals.
>Remember the front panel will only work with CPU cards that have the CPU
>data bus availible on a 16 pin socket, and port FF is used by the front
>panel data in/out port so beware of address conflicts.

etc...

Those are some good suggestions, however, I get a triangle wave even when the 
front panel is not connected, and I run a little program that loops to itself
in ROM...It doesn't, however, seem to affect the operation of the board, as 
it DOES work...Just wish I could get those damn drives going...

Mark


+-----------------------------------------------------------------------------+
+  Things are not what   |Albert Einstien got his name after he got smashed   +
+  they appear to be...  |after drinking one stien of beer. Hence; Albert     +
+________________________|EinStien.___________________________________________+
+  Ack! Ack! Ack! Ack! Ack!  |Mark D. Kakatsch --> paravia@csd4.milw.wisc.edu +
+  Pfhtph! Pfhtpph! Pfhtpf!  |                     uwmcsd1!uwmcsd4!paravia    +
+-----------------------------------------------------------------------------+