Who has dummy speaker loads?

Article View: sci.electronics

Article #21149

#21149

From: Cliff Yamamoto
Date: Thu, 13 Apr 1989 15:08

17 lines
1403 bytes

Greetings!

	Can someone recommend I manufacturer of dummy speaker loads?  I don't
feel like soldering dozens of wire-wound resistor together on a huge heat sink.
Something like a 50 Watt, 4 or 8 ohm load would be preferable.  The last time
I saw a dummy load was in a stereo repair shop, but they were using a single
50 Watt wire-wound from Dale the size of a spray can!

	The reason for the load is I'm installing a removable sub-woofer in the
car and when it's not in there, I've been told the amp should have a dummy
load even if when little or signal is coming through.  Is this true?

Thanks in advance
Cliff Yamamoto
-------------------------------------------------------------------------------
Internet:  cyamamot@castor.usc.edu    castor!cyamamot@oberon.usc.edu
           cyamamot@nunki.usc.edu     cyamamot%nunki.usc.edu@oberon.usc.edu

Technical Details

Message-ID: <3474@nunki.usc.edu>

Path:

arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!oberon!nunki.usc.edu!castor.usc.edu!cyamamot

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!oberon!nunki.usc.edu!castor.usc.edu!cyamamot
From: cyamamot@castor.usc.edu (Cliff Yamamoto)
Newsgroups: sci.electronics,rec.audio
Subject: Who has dummy speaker loads?
Keywords: dummy, speaker, load, watt
Message-ID: <3474@nunki.usc.edu>
Date: 13 Apr 89 15:08:49 GMT
Sender: news@nunki.usc.edu
Reply-To: cyamamot@castor.usc.edu (Cliff Yamamoto)
Distribution: na
Organization: University of Southern California, Los Angeles, CA
Lines: 17