🚀 go-pugleaf

In article <3139@kitty.UUCP> larry@kitty.UUCP (Larry Lippman) writes:
>
>> Even if you could, you would have to
>> cope with the possibility of an incoming ring signal, which is
>> typically 60-90 VAC!  (Yes, Virginia, you can ring a phone with house
>> current.)
>
>	Sorry, but you canNOT ring a phone with "house current".  Virtually
>all conventional telephone ringers are frequency selective, and operate only
>between 16 and 32 Hz; 60 Hz won't cut it.  Some ringers used on older
>party line systems (like the "harmonic", "decimonic" and "synchronic") were
>_very_ freqeuncy selective, with a "bandpass" of 5 Hz or less.

You are correct that the ring signal's frequency is nominally 20 Hz,
but you can ring a telephone with house current.  I have done it with
several different (Bell) telephones of varying vintage.  It isn't very
efficient, since the coils are tuned for 20 Hz, but it works.  (Of
course the set must be on-hook for this to work.)


Longish .signature follows.  Skip now, or don't complain.

Greg Wageman			DOMAIN: greg@sj.ate.slb.com
Schlumberger Technologies	UUCP:   ...!uunet!sjsca4!greg
1601 Technology Drive		BIX:    gwage
San Jose, CA 95110-1397		CIS:    74016,352
(408) 437-5198			GEnie:  G.WAGEMAN
------------------
"Live Free; Die Anyway."
------------------
Opinions expressed herein are solely the responsibility of the author.