Stepper Motors

Article View: sci.electronics

Article #21727

#21727

From: Gregory N. Shapiro
Date: Sat, 10 Jun 1989 02:36

16 lines
1272 bytes

Does anyone have any information on how to get a computer to control
the running of a stepper motor through it's serial port.  The computer
I would like to use is a Macintosh.  If anyone has any information
regarding this topic, please mail it to me.  Thank you.

						Greg

 ____________________________________________________________________________

 Gregory Shapiro                                              Gregory Shapiro
 Worcester Polytechnic Institute              Worcester Polytechnic Institute
 GSHAPIRO@WPI.BITNET                                                 Box 1397
 GSHAPIRO@WPI.WPI.EDU (130.215.24.1)                       100 Institute Road
 GEnie: THE.CYCLOPS                            Worcester, Massachusetts 01609
 MacNet: GShapiro                                               United States
 ____________________________________________________________________________

Technical Details

Message-ID: <2668@wpi.wpi.edu>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!cs.utexas.edu!husc6!m2c!wpi!gshapiro

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!cs.utexas.edu!husc6!m2c!wpi!gshapiro
From: gshapiro@wpi.wpi.edu (Gregory N. Shapiro)
Newsgroups: sci.electronics
Subject: Stepper Motors
Keywords: Motor Serial
Message-ID: <2668@wpi.wpi.edu>
Date: 10 Jun 89 02:36:18 GMT
Organization: Worcester Polytechnic Institute, Worcester, Mass.
Lines: 16