🚀 go-pugleaf

I have a couple of motors that I'd really like to use, except
that I'm having some trouble figuring out how they need to be
hooked up.  Could someone out there please email me if you
can shed some light on this problem?

The motors are about 2" in diameter, 2" long, and were made
by Kearfott.  The sides bear the following diagram:	


    Frequency 400 cycles

  ___  Phase 1 115V ___
 |                     |
 |                     |
[1]        [2]        [3]
            |__________________

                               Phase 2
                               115V	
[6]        [5]        [4]______	
 |__________|           


I am fairly sure that the problem is in the 400 cycle bit,
the two phases, or both...but I'm not at all sure if I can
do anything about it!  I'd really appreciate any assistance
I can get...please reply via email if you wouldn't mind, as
I already subscribe to more newsgroups than I probably should!

Thanks,
pat