Article View: sci.electronics
Article #3426Re: Speaker phone needed (circuit?)
From: Mike Morris
Date: Sun, 15 Oct 1989 06:56
Date: Sun, 15 Oct 1989 06:56
44 lines
2821 bytes
2821 bytes
In article <6584@viscous.sco.COM> rosso@sco.com (Ross Oliver) writes:
%
%In article <3268@puff.cs.wisc.edu> aber@gumby.cs.wisc.edu (David Aber) writes:
%>I am looking for a GOOD speaker phone. Most of the ones I have seen are only
%>half duplex. The one full duplex one I found has very low volume. I don't
%>know if this it to prevent the echos from being picked up or what.
%
%Since the speaker and microphone are usually right next to each other
%on the phone, most speaker phones are half-duplex to prevent feedback,
%and the ear-splitting whine that results.
%
%>What I would really like is a speaker phone with:
%>
%> Lots of volume; both ways (Its not fair to make the other person
%> listen to you from the end of a cave)
%
%You're fighting the inverse-square law here. The sound energy of your
%voice receieved by the microphone falls off in proportion to the square
%(or is it the cube?) of your distance from it. However, the background
%noise and echoes remain at the same level. A studio-quality directional
%microphone might help. Getting the microphone away from the speaker
%would also reduce feedback and allow you to use full duplex.
Years ago a ham radio acquaintance built a wireless mike in a small box
that would fit in a shirt pocket. The device ran a few mw on a FM frequency
(i.e. license free) and worked very well as a "microphone" for a speakerphone
since the "mike" was kept away from the speaker. He later added a jack
for a "plantronics" style headset - he had picked one up with a dead
earpiece for free.
Another cute trick that can be done with a "PC-4" style speakerphone from
Ma Bell (the kind with a rocker-style on-off switch) is to disassemble the
mike unit, and install a 1/8" closed-circuit jack in the mike element
leads. Plug in a good quality electret desk mike. This trick will
improve the speakerphone audio quality 100% (and it's pretty good to
start with... Well, pretty good as far as speakerphones go...).
ZZ
Mike Morris UUCP: Morris@Jade.JPL.NASA.gov
ICBM: 34.12 N, 118.02 W
#Include quote.cute.standard PSTN: 818-447-7052
#Include disclaimer.standard cat flames.all > /dev/null
Technical Details
Message-ID:
<1913@jato.Jpl.Nasa.Gov>Path:
arc1-ca.pugleaf.net!utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!wuarchive!gem.mps.ohio-state.edu!usc!henry.jpl.nasa.gov!elroy.jpl.nasa.gov!jato!jade!morrisReferences:
<3268@puff.cs.wisc.edu> <6584@viscous.sco.COM>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!attcan!utgpu!jarvis.csri.toronto.edu!mailrus!wuarchive!gem.mps.ohio-state.edu!usc!henry.jpl.nasa.gov!elroy.jpl.nasa.gov!jato!jade!morris From: morris@jade.jpl.nasa.gov (Mike Morris) Newsgroups: sci.electronics Subject: Re: Speaker phone needed (circuit?) Message-ID: <1913@jato.Jpl.Nasa.Gov> Date: 15 Oct 89 06:56:13 GMT References: <3268@puff.cs.wisc.edu> <6584@viscous.sco.COM> Sender: news@jato.Jpl.Nasa.Gov Reply-To: morris@jade.Jpl.Nasa.Gov (Mike Morris) Distribution: usa Lines: 44