Re: PCB vs. wirewrap

Article View: sci.electronics

Article #3728

#3728

From: Ken Young
Date: Tue, 14 Nov 1989 20:15

12 lines
973 bytes

In article <850@carroll1.UUCP> dnewton@carroll1.cc.edu (Dave 'Post No Nicknames' Newton) writes:
>   I don't like routing PCBs by hand, but I don't like wire-wrapping large 
>boards either.  (Manual tool at this point)
>   Is either one of them better?  I've heard that a lot of critical circuits
>are wire-wrapped for reliability.  Is this true?  Is wire wrap harder to debug?

Rules of thumb(s):
Wire wrap is less reliable.
Wire wrap is cheaper for one board, but if you need more than one, make it a PCB.

Ken Young
uunet!auspex!kyoung

Technical Details

Message-ID: <2629@auspex.auspex.com>

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!ucsd!usc!cs.utexas.edu!uunet!auspex!kyoung

References: <850@carroll1.UUCP>

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!ucsd!usc!cs.utexas.edu!uunet!auspex!kyoung
From: kyoung@auspex.auspex.com (Ken Young)
Newsgroups: sci.electronics
Subject: Re: PCB vs. wirewrap
Message-ID: <2629@auspex.auspex.com>
Date: 14 Nov 89 20:15:02 GMT
References: <850@carroll1.UUCP>
Reply-To: kyoung@auspex.auspex.com (Ken Young)
Distribution: usa
Organization: Auspex Systems, Santa Clara
Lines: 12

Reply to Parent Message