🚀 go-pugleaf

Brent Beseler writes:

>Would the following idea work:
>
>Suppose the reciever horn of a detector is mounted in front of the engine grill
>etc. in a hidden location.  Right behind the horn would be a microwave amplifie
>r circuit.  That would feed into a cable.  The cable would run to a well shield
>ed reciever.  This system would not emit the 11.5 Ghz frequency that the
>radar detector detection systems use.
>                                          Brent H. Besler
>                                          FOrd Motor Scientific Res. Lab


	Yes, it is possible for a system such as you describe to be built
that would not radiate the local oscillator.  In addition to a preamp, a
filter would also help.  (You would ideally have a separate filter/preamp/
mixer for each band)  As you state you would also need a well shielded 
receiver.  This is a non-trivial task, depending on how close you want to 
be able to get without your LO being detected.  Shielding 11GHz effectively
is tough, but can be done.  I doubt it can be done at the prices they sell
commercial radar detectors for.

______________________________________________________________________________

   _   /| 	-ACK!        Bill (the) Katz     Internet: billk@hpsad.hp.com
   \'o.O'	-PFHHHT!     Hewlett-Packard         UUCP: hplabs!hpsad!billk
   =(___)=	-COUGH!      Signal Analysis Div.   Phone: (707) 794-2300
      U		-ACK!	     1212 Valley House Dr.    Fax: (707) 794-4452
			     Rohnert Park, CA 95428
______________________________________________________________________________