🚀 go-pugleaf

In article <1109@uvicctr.UVic.CA.UUCP>, climber@uvicctr.UVic.CA.UUCP (climber) writes:
> connection between top and bottom traces).  Is there a way I,
> a hobbyist with measly resources, can build a two-sided board
> with plated thru holes?  I would like to avoid the following:

Ummm, after a little bit of experience and lots of reading and asking
questions, my answer is "no". The best you can do with hobbyist level
equipment is to drill a hole, put pads around it on both sides, solder a
piece of wire through it on both sides, and run traces from that. It takes
up a bit more room, but not much if you're careful. 

Remember also, things like resistor leads and IC pins can be soldered on
*both* sides of the board: it makes them tougher to replace, but they can
carry your signal for you. And if you have to replace it, plated through
holes are a pain to desolder anyway.

-- 
			Nico Garcia
			Designs by Geniuses for use by Idiots
			eplunix!cirl!raoul@eddie.mit.edu