Op amp configuration question

Article View: sci.electronics

Article #491

#491

From: Richard Banks
Date: Wed, 04 Nov 1992 22:59

12 lines
890 bytes

I'm building a circuit where I need high gain.

I was going to get two single op amps and send the output of one
to the input of the other one.

But would it be possible for me to just get a dual op amp IC
and send the output of one to the input of the other on the same chip?!

If this is possible is it a standard practice?

Thanks.

Technical Details

Message-ID: <1d9kjtINNna1@usenet.INS.CWRU.Edu>

Path:

arc1-ca.pugleaf.net!sparky!uunet!charon.amdahl.com!pacbell.com!decwrl!sdd.hp.com!zaphod.mps.ohio-state.edu!magnus.acs.ohio-state.edu!usenet.ins.cwru.edu!cleveland.Freenet.Edu!ah335

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!sparky!uunet!charon.amdahl.com!pacbell.com!decwrl!sdd.hp.com!zaphod.mps.ohio-state.edu!magnus.acs.ohio-state.edu!usenet.ins.cwru.edu!cleveland.Freenet.Edu!ah335
From: ah335@cleveland.Freenet.Edu (Richard Banks)
Newsgroups: sci.electronics
Subject: Op amp configuration question
Date: 4 Nov 1992 22:59:09 GMT
Organization: Case Western Reserve University, Cleveland, OH (USA)
Lines: 12
Message-ID: <1d9kjtINNna1@usenet.INS.CWRU.Edu>
Reply-To: ah335@cleveland.Freenet.Edu (Richard Banks)
NNTP-Posting-Host: slc10.ins.cwru.edu