🚀 go-pugleaf

Greetings.
I'm going to be doing a good amount of assembly of wire wrapped prototypes.
I've heard tell of labels that you peel off and stick down on the circuit
board alongside the WW socket.  THese labels are numbered and make it much
easier to find the correct pin on the underside of the socket.
    Has anybody out there encountered such a product?
BTW-I know about the plasticlabels that you simply slide over the pins
before you start wrapping, but I'd like something that can be removed
after assembly is complete.
    Pls e-mail any responses, as I only peruse this newsgroup once a week
or so.
 
Thanks in advance.
 
Seth Wolpert.
 
 
******************************************************************
** Seth Wolpert              ** No matter what occurs, there is **
** The University of Maine   **  always someone who believes it **
** AMA #519024 BMWMOA #40029 **  happened according to his pet  **
** DIOC #5556  DoD #40       **  theory.   Finagle's third law  **
******************************************************************