🚀 go-pugleaf

In article <1063@tsdiag.ccur.com> davet@tsdiag.ccur.com (Dave Tiller N2KAU) writes:
[ talking about a power amp for a walkie-talkie and using an op-amp ]

> The easiest method, if it were legal, would be to use a final
>transistor current amp (common collector).  There are lots of transistors 
>that'll handle 27 MHz just fine.

   Common collector? Hmm, most of the RF amplifiers use NPN transistors in
a common emitter configuration. At 27 Mhz, you could even use a cheap
power MOSFET like the IRF511; I built a 10m amp using one of these and
got something like 13 dB+ of power gain at 29.0 Mhz (15W out). Of course,
the MOSFET amplifier was common source, with about 50mA of idle current.
What was funny, for that project I built an RF-sensed T/R switch, and ended
up using the same active device as the power amplifier to drive a relay...

  Once again, however, please DO NOT build your own power booster for a 
27Mhz or 49Mhz handie talkie.
*****************************************************************
* Dana H. Myers KK6JQ 		| Views expressed here are	*
* (213) 337-5136 (ex WA6ZGB)	| mine and do not necessarily	*
* dana@locus.com		| reflect those of my employer	*
*****************************************************************