🚀 go-pugleaf

[needed debouncing, if I understood correctly]

I built some special IO boards for a DEC Falcon {a micro-PDP-11 beast}
that had to debounce switch inputs. I used a 16 pin dip hex debouncer.
I *think* it was a 14490, or 14409, but it's been a while;-}

In any case, its law was simple: For the output to go up, the input had
to go up and stay up for 5 periods. To then go low again, it had to go
low and stay low, etc. You set the period of the internal clock with a
cap I recall. There was WIDE variation in periods available -- maybe
large us to several seconds.

It worked well for me on several hundred boards with 8 per board. But I
should mention that another designer cursed it roundly, as he never had
any luck with it.
-- 
A host is a host from coast to coast.....wb8foz@mthvax.cs.miami.edu 
& no one will talk to a host that's close............(305) 255-RTFM
Unless the host (that isn't close)......................pob 570-335
is busy, hung or dead....................................33257-0335