🚀 go-pugleaf

Things are slow, so I thought a little humor might be warranted...

In article <4094@tekig4.LEN.TEK.COM> James W. Edwards writes:

=I have a problem for you electronics wizards.  I would like to control
=the DC power being supplied to two loads as shown in the following diagram:
=
=  +--[Load 1]-------------[CP1]-------------+-------+
=  |                                         |       |
=  |                                         |       DC
=  +--[Load 2]-------------[CP2]-------------+      POWER
=  |                                                 |
=  |                                                 |
=  |                                                 |
=  +-------------------------------------------------+
=						    |
=       					           GND
=
=CP1/2 = Control Points 1/2
=
=I would like to be able to turn on/off the power to either of
=the loads through CP1/CP2.  CP1/CP2 are simply whatever electrical
=component(s) that you feel would be necessary to achieve this objective.
=The switching action of CP1/2 must be controllable through a digital
=signal.  CP1/2 must each be able to switch 15A @ 12/24 V to their loads.

When I got this far, a solution popped right into my head.  CP1 and CP2 are
standard 15A toggle switches, the digital control being a finger of your
choice.  Simple, cheap, reliable.


Rich
-- 
---------------------------------------------------------------------------
Ideas have consequences.                                    RSD@sei.cmu.edu
Richard Weaver
---------------------------------------------------------------------------