Need to boost output of op-amp (programmable power supply)

Article View: sci.electronics

Article #8404

#8404

From: david scott coburn
Date: Thu, 15 Nov 1990 20:55

14 lines
1292 bytes

I have a thermo-electric heat-pump that I need to supply power to.
I have a small op-amp circuit that conditions a control signal from
our temperature controller.  I would like to know if there is a way
that I can 'super-charge' the output of the op-amp to provide 0 to 5
amps at 0 to 3.5 volts.  This project is at the experimental level at this
point so I am not ready to shell out the bucks for a programmable power
supply.  If someone could point me to an application note or such, that
would be great.

Any help would be appreciated.

scott coburn                                brookhaven national laboratory
scottc@solids.phy.bnl.gov [130.199.128.73]                  upton, ny, usa
 .....q.. ...q.... ......q. q....... .......q .q...... ....q... ..q......

Technical Details

Message-ID: <2316@bnlux0.bnl.gov>

Path:

arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!rutgers!orstcs!ogicse!dali.cs.montana.edu!uakari.primate.wisc.edu!zaphod.mps.ohio-state.edu!caen!umich!sharkey!bnlux0!scottc

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!rutgers!orstcs!ogicse!dali.cs.montana.edu!uakari.primate.wisc.edu!zaphod.mps.ohio-state.edu!caen!umich!sharkey!bnlux0!scottc
From: scottc@bnlux0.bnl.gov (david scott coburn)
Newsgroups: sci.electronics
Subject: Need to boost output of op-amp (programmable power supply)
Keywords: op-amp output boost programmable power supply
Message-ID: <2316@bnlux0.bnl.gov>
Date: 15 Nov 90 20:55:09 GMT
Distribution: usa
Organization: Brookhaven National Lab
Lines: 14