🚀 go-pugleaf

In article <1990Nov27.200947.2614@eddie.mit.edu>, rs@mit-eddie (Robert E. Seastrom) writes...
> 
>I've recently acquired an intelligent EPROM burner, as described in
>the October 1986 copy of Byte.  Can someone please tell me the pinout
>for J1, so that I can hook power up to it?  I'm supposed to supply
>+12, +5, and -5 to -12 volts, but it doesn't describe the pinout for
>the connector.

I have the manual that comes with the kit and it shows the top view of the
connector like this:

	+--------------+
	|              |
	+--------------+ <- a wavy piece of plastic
	|              |
	|  o  o  o  o  |
	|              |
	+--------------+
           ^  ^  ^  ^
           |  |  |  |
           |  |  |  +-  Ground
           |  |  +-  +5V
           |  +-  +12V
           +-  -5V to -12V

The ground pin appears to be the one nearest the corner of the board.  It
should be easy to verify the ground and +5 volt connections.

Hope this helps.

John

----------------------------------------------------------------------
John F. Wood                  | EIS Engineering
Digital Equipment Corporation | ARPAnet: wood@acesmk.enet.dec.com
Continental Blvd.             | EASYnet: ACESMK::WOOD
MKO2-1/J12                    | Usenet : ...!decwrl!acesmk!wood
Merrimack, NH  03054          | AT&T   : (603) 884-4686
----------------------------------------------------------------------
Disclaimer: Views expressed herein are my own and do not necessarily
            reflect those of my employer.
----------------------------------------------------------------------