🚀 go-pugleaf

I would like info on this system too!

I saw a milling mach. fot 2 sided boards for $15k. (too much for me)
 I found my TEC200 doesn't work with some copiers.   Either the plastic 
gets stuck or the toner doesn't melt off.

In article <Jan.22.14.13.10.1991.28324@aramis.rutgers.edu> scafidi@aramis.rutgers.edu (John Scafidi) writes:
>Recently I got some information in the mail from HTE Corporation in
>San Diego. They sell a pcb prototyping system that enables you to make
>single, double and multilayer printed circuit boards. It consists
>mainly of a plotter that draws the traces on the pcb with an etch
>resistant ink. The plotter also has a drilling attachment to drill the
>holes and vias. The system also includes a tank for the sodium
>persulphate etchant.
>
>I would appreciate if any fellow sci.electronics netters who are
>experienced in making pcbs would comment on this system. Of course,
>I would like to hear from anyone who has the HTE system. But this is
>a new product and I'm not sure that anyone who owns a system will have
>access to the net.  
>
>Any comments posted to this newsgroup or emailed to me will be greatly
>appreciated.

~ Jerry Bemis  Sunnyvale, CA (408) 749-3327  (800) 538-8450 x43327  ~
~ >INTERNET LPDJB@brahms.amd.com                                    ~