🚀 go-pugleaf

I have just bought a power supply module from a 'electronic junk shop'
and am not sure which of its pins to connect the mains input to!  so
I thought I would see if any of you peeps in netland knew anything of
this beast before I blow it up...

It is made by CONTROL DATA and has a part # 62166100 and claims outputs
of +5 +12 -12 +13 and 6.3ac!  Inputs are 120/220/230 and the power input
block looks like...

  o o o     one of the 6 pins goes to ground
            and there is a low resistance between 2 of the pins
  o o o     and between three of the pins..

I am wondering if there are perhaps 2 windings that should be connected
in series for 230v or parallel for 110v ( I want 230v )

Any ideas????
__________________.         _--_|\         .______________________________
Clive Salvidge    |        /      \        | Internet :  clive@aldetec.oz.au
Aldetec Pty Ltd   |        \_.--._/        | ACSnet   :  clive@aldetec.oz 
Western Australia |              v         | Voice    :  +61-9-4451888
_________< Due to a lack of imagination, this space is blank ! >__________