🚀 go-pugleaf

RetroBBS NetNews Server

Inspired by RockSolid Light RIP Retro Guy

Article View: sci.electronics
Article #21970

Re: Electric Fences (safety)

#21970
From: John Witters
Date: Wed, 03 Jan 1990 18:52
36 lines
2425 bytes
In article <13569@fluke.COM> vince@tc.fluke.COM (Craig Johnson) writes:
>The moral:  Don't assume all electric fences are safe to grab!  You may
>be betting your life if you are wrong!

Let me add to this.  When I was a kid we had an electric fence charger we used
to keep our cattle from knocking down fences.  The charger ran off the AC mains
and had a step up transformer in series with an interrupter and with fuses on
both the primary and secondary.  The interrupter applied power to the fence for
one second every two seconds (i.e. a 0.5 Hz square wave).  One of the
advertised features of this charger was that the arc it put out would cut down
any weeds that happened to fall or grow into the fence.

We used pieces of insulated wire to electrify sections of the fence.  One
morning I went out to do something and I grabbed the insulated wire to
disconnect a section of fence.  As it happened, there was a hole in the
insulation where I grabbed it.  Since it was morning, there was dew on the
ground, and since it was summer, I was barefoot.  Well, the interrupter applied
power to the fence, and I found myself paralyzed for the next second until the
interrupter removed power.  While I was standing there I smelled something
burning.  When I was able to remove my hand from the wire, I found a small hole
etched into the skin on my thumb.  I didn't think much about it at the time,
but now I realize that the interrupter may have saved me from something worse
than a sore thumb.

Next Time:  What happened when my dog pissed on the fence.

-John

-- 
    *  *  *		John Witters			voice:	(206) 356-5274
  *  \      *		John Fluke Mfg. Co. Inc.
 *    \      *		P.O.B. C9090 M/S 245F		fax:	(206) 356-5116
* P A G\I N G *		Everett, Washington  98206	     or (206) 356-5174
 *      \    *
  *      \  *		domain:	witters@fluke.COM
    *  *  *		uucp:	{sun,microsoft,uw-beaver}!fluke!witters
Technical Details
Message-ID: <13591@fluke.COM>
Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!wuarchive!mit-eddie!uw-beaver!fluke!witters
References: <5593@shamu.WV.TEK.COM> <12346@cbnewse.ATT.COM> <25525@cup.portal.com> <13569@fluke.COM>

Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!wuarchive!mit-eddie!uw-beaver!fluke!witters
From: witters@tc.fluke.COM (John Witters)
Newsgroups: sci.electronics
Subject: Re: Electric Fences (safety)
Message-ID: <13591@fluke.COM>
Date: 3 Jan 90 18:52:45 GMT
References: <5593@shamu.WV.TEK.COM> <12346@cbnewse.ATT.COM> <25525@cup.portal.com> <13569@fluke.COM>
Sender: news@tc.fluke.COM
Distribution: na
Organization: John Fluke Mfg. Co., Inc., Everett, WA
Lines: 36