Article View: sci.electronics
Article #9859Re: Converting to NTSC from PAL
From: Dan Meyer
Date: Fri, 01 Feb 1991 00:25
Date: Fri, 01 Feb 1991 00:25
30 lines
1687 bytes
1687 bytes
myers@hpfcdj.HP.COM (Bob Myers) writes:
>>How difficult would it be to modify an old VCR to play and record tapes in the
>>PAL format?
>
>Damned near impossible. It would be the electronic equivalent of jacking up
>the radiator cap and sliding a new car underneath.
>
>You'd be better off just getting a PAL (or multi-mode) VCR and TV. (Note
>that the line rate, etc., aren't compatible with U.S. TVs, either, so just
>a PAL VCR isn't going to make you any better off than you are now.
>
>
>
>Bob Myers KC0EW HP Graphics Tech. Div.| Opinions expressed here are not
> Ft. Collins, Colorado | those of my employer or any other
>myers@fc.hp.com | sentient life-form on this planet.
O Really? I was under the impression that a standard US tv could pick up
european transmissions under the proper "skip" conditions. Of course, the
aspect ratio would be wrong, and there would be no color, but the picture
_would_ be viewable. Am I incorrect?
-- Dan Meyer
N0KFB
Remember: " Buffalo never Oink " Seen on a South Dakota travel brocure.
Advertisment: Try the Railway Post Office , a railfan BBS ! (612) 377-2197.
UUCP: {crash tcnet}!orbit!pnet51!rambler
ARPA: crash!orbit!pnet51!rambler@nosc.mil
INET: rambler@pnet51.orb.mn.org
Technical Details
Message-ID:
<3956@orbit.cts.com>Path:
arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!ucsd!nosc!crash!orbit!pnet51!ramblerShow Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!ucsd!nosc!crash!orbit!pnet51!rambler From: rambler@pnet51.orb.mn.org (Dan Meyer) Newsgroups: sci.electronics Subject: Re: Converting to NTSC from PAL Message-ID: <3956@orbit.cts.com> Date: 1 Feb 91 00:25:02 GMT Sender: news@orbit.cts.com Organization: People-Net [pnet51], Minneapolis, MN. Lines: 29