Article View: sci.electronics
Article #15972Re: Good way to prototype analog circuits?
From: Jim Kurdzo
Date: Mon, 04 Jan 1993 02:27
Date: Mon, 04 Jan 1993 02:27
26 lines
1308 bytes
1308 bytes
John Paul Morrison (jmorriso@ee.ubc.ca) wrote: > > Does anyone want to share their tips on prototyping analog circuits? > Specifically: sensitive, high gain circuits; RF circuits etc. > > These kind of circuits work well with PC boards with ground planes, > but are there any simple, easy to make changes, techniques for this? > Are there any pre-made boards with a ground plane, and holes with solder > contacts on them? > I always use the pre-punched vector board with copper clad on one side. Vector p/n 169P84WEC1 is 8.5" x 17" and available from Digi-Key for around $20. Just cut it up into smaller pieces with tin snips. Wherever you DON'T want a ground connection, ream out the ground plane with a 1/4" drill bit. Good Luck! -- Jim Kurdzo N1KKA General DataComm Middlebury, CT 06762-1299 (203) 758-1811 x7550 kurdzo@gdc.com
Technical Details
Message-ID:
<686@esun179.gdc.com>Path:
arc1-ca.pugleaf.net!sparky!uunet!psinntp!gdc!kurdzoReferences:
<1993Jan3.231733.15225@ee.ubc.ca>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!sparky!uunet!psinntp!gdc!kurdzo From: kurdzo@gdc.com (Jim Kurdzo) Newsgroups: sci.electronics Subject: Re: Good way to prototype analog circuits? Message-ID: <686@esun179.gdc.com> Date: 4 Jan 93 02:27:53 GMT References: <1993Jan3.231733.15225@ee.ubc.ca> Sender: news@gdc.com Organization: General DataComm Ind. Inc., Middlebury, CT 06762 Lines: 27 Nntp-Posting-Host: esun_server40 X-Newsreader: TIN [version 1.1 PL6]