🚀 go-pugleaf

reuber@world.std.com (kent b reuber) writes:
>Having problems configuring and LN03 on a terminal server. System version
>is VMS 5.3. I can connect the printer and do a TEST PORT 1, I get a test
>page as expected. But when I try copying to the device, I get the message
>
>RMS-F-WER, file write error
>SYSTEM-F-HANGUP, data set hangup
>
>I've checked the name of the server and the port name, but that seems OK.
>Anything else that looks like a likely snafu. This seems to be an
>intensely painful process fraught with peril.
 
We've run into this problem a few times over the past couple of years also. 
Usually it has to do with either the terminal server not being defined properly
in the NCP database (primarily the name) or the port name is defined
incorrectly.  I believe these names are case-sensitive.  Also, we've found, on
occasion, that another system has channels open to the port that the LN03 is
connected to , thereby yielding the "data set hangup" messages.  You merely
need to log out the port on the terminal server to resolve this problem.
 
Good luck!
 
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
  Jeff Hoverson                    |       (619)535-7043
  SAIC                             |       Hoverson@Fwva.Saic.Com
  10260 Campus Point Dr., MS D2    |       VAX/VMS System Manager
  San Diego, CA  92121             |       But, I coulda' been ....
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-