🚀 go-pugleaf

In article <35827e12.28480806@news.isomedia.com>, Oof@Da.com says...
>
>Just bought this board, but it came without a manual.
>
>It has a DB-25 F parallel port and a DB-9 M serial port on the card.
>It has a 10-pin jumper and flat ribbon cable to a second blank card
>end, with a DB-25 M serial port.
>
>So, standard, it has two S and one P port.  The Serials are 16550.
>
>To set the IRQ and Port numbers for all three, it has two cryptic
>jumpers, each with a 2x7 pin layout, looks like the layout below
>(apparently the label HIJKLMN serves as pin numbering for the closest
>row of 7 pins of both JP1 and JP2):

< text cut >

>I can't believe the SIIG home page doesn't have PDFs of their product
>manuals.  Wouldn't that offload the time required to answer tech
>questions?
>
>Thanks for any ideas.  Please reply to the newsgroup.


I have a SIIG 16550 serial (2) & IEEE 1284 (EPP/ECP) Parallel (1) port 
card..
the pin out is as follows

       JP1
      L   H
 1  o   o   o  Serial Port 1                  Serial Port 2
 2  o   o   o  JP1- 1 Low  = Disable          JP1- 2 Low  = Disable
 3  o   o   o  JP1- 1 High = Enable           JP1- 2 High = Enable
 4  o   o   o  JP1- 5 Low  = COM 3 (3E8-3EF)  JP1- 6 Low  = COM 4 (2E8-2EF)
 5  o   o   o  JP1- 5 High = COM 1 (3F8-3FF)  JP1- 6 High = COM 2 (2F8-02F)
 6  o   o   o  JP1- 9 Low  = IRQ 3            JP1- 9 Low  = IRQ 3
 7  o   o   o  JP1-10 Low  = IRQ 4            JP1-10 Low  = IRQ 4
 8  o   o   o  JP1-11 Low  = IRQ 5            JP1-11 Low  = IRQ 5
 9  o   o   o  JP1-12 Low  = IRQ 6            JP1-12 Low  = IRQ 9
10  o   o   o
11  o   o   o   Parallel Port (LPT)
12  o   o   o   JP1- 7 Low  = 278h-27Fh
      L   H     JP1- 7 High = 378h-37Fh
                JP1- 8 Low  = IRQ 5  
                JP1- 8 High = IRQ 7

Also has FAST Parallel 8-bit bi-directional and DMA configuration but, I do 
not think that your card has that.

Try running MSD.EXE in the DOS dir to see system configuration.
Good luck!

*********************************************
*      Sam Cambron, cambrons@swbell.net     *
*          Del City, Oklahoms, USA          *
* If you stand in the road for a long time, *
*           you WILL get run-over           *
*********************************************