🚀 go-pugleaf

Ok, now I have my system all kinds of FUBAR.  I found the as86 prog off
the internet and finally got the make bzImage work... now when I placed
the bzImage into the boot directory and vi lilo.conf then ran lilo.
Rebooted and chose my newlinux kernal and my computer rebooted. After a
few explertives I rebooted to find I can no longer use my ppp connection
or my network card through the xwindows, It just sits there... no dial
tone or anything?  Anyone know what I did this time?

thanks ahead of time..

Rick

On Tue, 30 Mar 1999, Jose M. Urena wrote:

> nothing, apparantly you do not have the assembler.
> 
> do a whereis or locate or find for as86
> 
> Rick Runowski wrote:
> 
> > Ok, I ran into a problem seconds after my last post... I was performing
> > the make boot, and the program exited with:
> >
> > (last few lines)
> >
> > nm vmlinux | grep -v '\(compiled\)\|\(\.o$)\|\( [aU]
> > \_\|\(\.\.ng$\)\|\(LASH[RL]DI\)' | sort > System.map
> > make [1]: entering directory '/usr/src/linux-2.2.4/arch/i386/boot'
> > as86 -0 -a -o bootsect.o bootsect.s
> > make[1]: as86: Command not found
> > make[1]: *** [bootsect.o] Error 127
> > make[1]: Leaving directory '/usr/src/linux-2.2.4/arch/i386/boot'
> > make: *** [boot] Error 2
> >
> > What did I do wrong?
> >
> > Thanks in advance!
> >
> > Rick
> >
> > On Sat, 27 Mar 1999, Christian D Freet wrote:
> >
> > > The newly compiled kernel is, I believe, in the /usr/src/linux/arch/i386/boot/ directory and
> > > it's called zImage, if you used the "make zImage" command... if you used the "make bzImage"
> > > command, as I did, it will be named bzImage.  Check out
> > > http://www.redhat.com/knowledgebase/kb/cache/37.html
> > >
> > > There is a good description of how to finish... make sure, after you copy the image to where
> > > ever you want it to stay permanently, that you modify the lilo.conf file to point to it (see
> > > the file... you'll know what I mean).  Then run lilo (e.g. type "lilo, [enter]") to map the
> > > kernel... then reboot.
> > >
> > > On Fri, 26 Mar 1999 20:04:05 -0600, Rick Runowski <runowsk@okstate.edu> wrote:
> > >
> > > >
> > > >Actually I am having a similar problem.  I downloaded the latest kernel
> > > >from ftp.kernel and I un tar/gz'ed it and I printed the instructions and
> > > >followed them.. I got to the compile Kernel... where is the kernel at?  Do
> > > >I use cc kernel... I can't find the instructions on compiling... I'm very
> > > >new to this... but where do I look... I tried the command below and got
> > > >about four lines all of which have errors on them?  Any help is
> > > >appreciated.
> > > >
> > > >Thanks
> > > >
> > --SNIP--
> 
> 
>