🚀 go-pugleaf

nothing, apparantly you do not have the assembler.

do a whereis or locate or find for as86

Rick Runowski wrote:

> Ok, I ran into a problem seconds after my last post... I was performing
> the make boot, and the program exited with:
>
> (last few lines)
>
> nm vmlinux | grep -v '\(compiled\)\|\(\.o$)\|\( [aU]
> \_\|\(\.\.ng$\)\|\(LASH[RL]DI\)' | sort > System.map
> make [1]: entering directory '/usr/src/linux-2.2.4/arch/i386/boot'
> as86 -0 -a -o bootsect.o bootsect.s
> make[1]: as86: Command not found
> make[1]: *** [bootsect.o] Error 127
> make[1]: Leaving directory '/usr/src/linux-2.2.4/arch/i386/boot'
> make: *** [boot] Error 2
>
> What did I do wrong?
>
> Thanks in advance!
>
> Rick
>
> On Sat, 27 Mar 1999, Christian D Freet wrote:
>
> > The newly compiled kernel is, I believe, in the /usr/src/linux/arch/i386/boot/ directory and
> > it's called zImage, if you used the "make zImage" command... if you used the "make bzImage"
> > command, as I did, it will be named bzImage.  Check out
> > http://www.redhat.com/knowledgebase/kb/cache/37.html
> >
> > There is a good description of how to finish... make sure, after you copy the image to where
> > ever you want it to stay permanently, that you modify the lilo.conf file to point to it (see
> > the file... you'll know what I mean).  Then run lilo (e.g. type "lilo, [enter]") to map the
> > kernel... then reboot.
> >
> > On Fri, 26 Mar 1999 20:04:05 -0600, Rick Runowski <runowsk@okstate.edu> wrote:
> >
> > >
> > >Actually I am having a similar problem.  I downloaded the latest kernel
> > >from ftp.kernel and I un tar/gz'ed it and I printed the instructions and
> > >followed them.. I got to the compile Kernel... where is the kernel at?  Do
> > >I use cc kernel... I can't find the instructions on compiling... I'm very
> > >new to this... but where do I look... I tried the command below and got
> > >about four lines all of which have errors on them?  Any help is
> > >appreciated.
> > >
> > >Thanks
> > >
> --SNIP--