🚀 go-pugleaf

you have a default route somewhere

route -n
find out where the default gw is and remove it and try again
(possibly route del default gw 192.168.0.1)

for a more permanent solution, you'll need to find and remove the default route from whatever config file it is.

"PèéJäy" <wiseguy@iinet..sp.a.m._.net.au> wrote in message news:3e23b449$0$238$5a62ac22@freenews.iinet.net.au...
> Ok, I've tried the standard driver that comes with Mandrake 9 with no
> success. Now I've downloaded speedtouch-1.1.tar.gz from sourceforge and can
> sort of make it work with:
> 
> modprobe ppp_generic
> modprobe ppp_synctty
> modprobe n_hdlc
> modem_run -v 2 -m -f /usr/share/speedtouch/mgmt.o
> 
> When it tries to load the microcode into the modem it gets about half of the
> first block done and then gets a timeout error. So I just run the modem_run
> command again and on the 2nd attempt it works. I then run "pppd call adsl"
> which works fine. (I've updated the vci/vpi in /etc/ppp/adsl). ifconfig
> gives:
> 
> ppp0      Link encap:Point-to-Point Protocol
>           inet addr:203.217.2.3  P-t-P:203.166.38.115  Mask:255.255.255.255
>           UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1520  Metric:1
>           RX packets:10 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:3
>           RX bytes:452 (452.0 b)  TX bytes:64 (64.0 b)
> 
> 
> Then I try and ping something (dns server on iinet.net.au)
> 
> [root@server zifnab]# ping 203.0.178.191
> PING 203.0.178.191 (203.0.178.191) from 192.168.0.1 : 56(84) bytes of data.
> From 192.168.0.1 icmp_seq=1 Destination Host Unreachable
> From 192.168.0.1 icmp_seq=2 Destination Host Unreachable
> From 192.168.0.1 icmp_seq=3 Destination Host Unreachable
> 
> and it tries to run via the LAN. Also there is no dns.
> 
> Any thoughts??
> 
> 
> 
> 
>