🚀 go-pugleaf

In message <3n4aef$jp6@otis.netspace.net.au> - imsic@netspace.net.au writes:
>I have just installed warp and it seemed to go on wihtout any problems.
>However when I turn the power off and turn the computer on again, it starts
>to load os2 but then I get the a series of numbers eg trap 000d ERRCD=0000
>ERACC=***** EAX=0000530b EBX=ff206e0 etc. and it finishes with the
>message.  System detected internal processing error at location
>##0160:fff5c34c-000d:a34c  60000, 9084   048600b4  internal revision
>8.162, 94/9/19.
>
>The problem does not occur with a ctrl-alt-del reset but only after i turn off
>my computer after installing os2.  I have tried installing os2 several times
>with the same result.  Can someone please HELP?

This is going to sound really silly, but are your c-mos settings for your 
floppy drives correct and the floppy drive plugged in?

I have similar problems when my son pinches my drive "a" and doesn't plug it 
back in. "He only has a 5.25 drive and nicks my 3.5 when he needs one. If you 
don't have drive "a" plugged in and set up, it barfs when you try to 
boot.

Just a thought

Graham