🚀 go-pugleaf

In article <3n4aef$jp6@otis.netspace.net.au>, imsic@netspace.net.au says:
>
>I have just installed warp and it seemed to go on wihtout any problems.
>However when I turn the power off and turn the computer on again, it starts
>to load os2 but then I get the a series of numbers eg trap 000d ERRCD=0000
>ERACC=***** EAX=0000530b EBX=ff206e0 etc. and it finishes with the
>message.  System detected internal processing error at location
>##0160:fff5c34c-000d:a34c  60000, 9084   048600b4  internal revision
>8.162, 94/9/19.
>
>The problem does not occur with a ctrl-alt-del reset but only after i turn off
>my computer after installing os2.  I have tried installing os2 several times
>with the same result.  Can someone please HELP?
>
>tia
>
>Michael
Must be a hardware setting or something in your boot ROM.

Remove any complex hardware connections and check if there is
some unusual jumper that was set up on your machine.  Have you asked
IBM about this.  They are pretty quick in trsacking down problems

The mouse will sometimes do things like this.

I am not an expert so take it for what it is worth.