🚀 go-pugleaf

If its a Onramp 2 both of the RJ45 connectors in the NT1 are in parallel so you
can use either one of these.The pinouts are the centre two on the RJ 45,(pins
3,6)for TX,and the two pins on either side of the centre two,(pins4,5 I think)for
RX.Your customer equipment should be configured as TE,ie Terminal Equipment.

Hope this helps.

Craig Dewick wrote:

> Hi,
>
> I've just tried to get the SunISDN software to set up a call over my OnRamp
> service, and it failed. It's probably a misconfiguration issue, but I'm also
> not sure which of the two ports on the back of my Sparc LX (NT or TE) the
> OnRamp NT1 should connect to... I've tried both with no conclusive results.
>
> The power supply unit also appears to be flaky... It seems to shut down
> after about an hour (presumably overheating inside). Does anyone know the
> correct pinout of the two-pin power connector at the bottom of the NT1 unit?
> I can easily rig up a small power supply here until I can get Telstra to
> look at the one they supplied, but I'm not sure of the pinout on the power
> connector.
>
> Regards,
>
> Craig.
> --
>             Craig Dewick. Send email to "cdewick@lios.apana.org.au"
>   Point a web browser at 'http://lios.apana.org.au/~cdewick/sun_shack.html' to
>     access my archive of Sun information and links to other places. For info
>           about Sun Ripened Kernels, go to "http://www.sunrk.com.au"