🚀 go-pugleaf

Hi,

    I new a Delphi package add some components (Delphi VCL),  compile,
build, install it.

    Then I new a Delphi VCL Form, In VCL pallete, I can see installed
components and use them without problem.

    Later, I new a bcb VCL Form, but I can't see the installed components
also shown in BCB VCL pallete. I wonder I have to new a BCB package and
repeat the installation procedure as done in Delphi package. So I did it.
Then compile, build, install this bcb package.  The same components now is
visible in BCB VCL pallete, works fine, too.

    But, after I close BDS2006, and open it again. It shows errors, said
same component in bcb package has been installed in delphi package, asking
whether attempt to load it next time........

    I choose 'yes', the BDS2006 IDE shows, I then new a BCB VCL Form, and go
to BCB VCL pallete, the installed components was disappear......


    How can I install the same components in both Delphi and BCB VCL pallete
without confilict error???


Thanks,

Daniel