🚀 go-pugleaf

I am using BDS4, calld Borland Delvelopment Studio 2006





"Daniel" <daniel@borland.com> ���g��l��s�D:43a0ff1a$1@newsgroups.borland.com...
> Hi,
>
>    I new a Delphi package add some components (Delphi VCL),  compile,
> build, install it.
>
>    Then I new a Delphi VCL Form, In VCL pallete, I can see installed
> components and use them without problem.
>
>    Later, I new a bcb VCL Form, but I can't see the installed components
> also shown in BCB VCL pallete. I wonder I have to new a BCB package and
> repeat the installation procedure as done in Delphi package. So I did it.
> Then compile, build, install this bcb package.  The same components now is
> visible in BCB VCL pallete, works fine, too.
>
>    But, after I close BDS2006, and open it again. It shows errors, said
> same component in bcb package has been installed in delphi package, asking
> whether attempt to load it next time........
>
>    I choose 'yes', the BDS2006 IDE shows, I then new a BCB VCL Form, and 
> go
> to BCB VCL pallete, the installed components was disappear......
>
>
>    How can I install the same components in both Delphi and BCB VCL 
> pallete
> without confilict error???
>
>
> Thanks,
>
> Daniel
>