Novell Lanalyzer

Thread View: comp.dcom.lans.ethernet

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by DEP Wed, 17 Feb 1993 21:45

#1200

Author: DEP
Date: Wed, 17 Feb 1993 21:45

18 lines
1599 bytes

We have three Novell Lanalyzer boards each installed in a Dolch 386 PC.
We have used these devices for the last several years for network
troubleshooting.

Suddenly, over the last four months, all three units have developed
an identical problem: the Novell Lanalyzer board will no longer supply
enough voltage to an attached transceiver (ST500). It seems to work
fine, however, when connected through an MT800, where, presumably, the
power is supplied by the multiport transceiver itself.

I'd be interested to know if anyone else has experienced this problem,
or if anyone knows the spec with regard to the pin and voltage level
so we could measure it.

Don Pelton ( dep@slacvm.slac.stanford.edu )
Stanford Linear Accelerator Center
Menlo Park, CA 94025
415/926-2901

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads