🚀 go-pugleaf

> I've got a problem on one of our IGS's running 8.2(4).
> 
> On Serial 0, the number of packets dropped is steadily increasing.
> However, the ouput queue never shows anything higher then 0/40: 
> 
> 
> Serial 0 is up, line protocol is up
>   Hardware type is MK5025
>   Internet address is 128.241.4.178, subnet mask is 255.255.255.240
>   MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, rely 255/255, load 4/255
>   Encapsulation HDLC, loopback not set, keepalive set (10 sec)
>   Last input 0:00:00, output 0:00:00, output hang never
>   Output queue 0/40, 26234 drops; input queue 6/75, 1 drops
>   Five minute input rate 26000 bits/sec, 44 packets/sec
>   Five minute output rate 29000 bits/sec, 58 packets/sec
>      6770743 packets input, 1363473461 bytes, 2 no buffer
>      Received 102246 broadcasts, 0 runts, 0 giants
>      121 input errors, 121 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
>      6594859 packets output, 688771269 bytes
>      0 output errors, 0 collisions, 0 interface resets, 0 restarts
>      0 carrier transitions
> 
> 
> The output rate is nowhere near the capacity of the line and the far end
> does not show any input errors.
> 
> Any ideas?
> 
> 
> -- 
> Evan 
> 
Your Case Number is:

	29878

We will begin working your problem shortly. Please reference this case
number in all correspondence on this subject. For email, begin your
subject line with "Case" followed by the number above. For example,
"Case 12345 additional info".
	
You may also contact the TAC (Technical Assistance Center) via
telephone at (800) 553-2447 or (415) 688-8209, or by FAX at (415)
688-7878. Our operating hours are 0600 to 1800 Pacific Standard Time,
USA. In all cases, providing your service contract number will
accelerate our assistance.
	-------------------------------------------------------


rep inc a