ASM Power Supply test points

Article View: comp.dcom.sys.cisco

Article #306

Back to comp.dcom.sys.cisco Previous Next

#306

From: Omar Barazanji
Date: Wed, 16 Sep 1992 02:37

15 lines
751 bytes




Dean

You can check the pins on the back plane for DC levels.
counting from left as you look at the front panel, pin 1
is +12V  next -12volts then +5 and -5 and there should be
ground in between. I could be wrong on the order though, however
you can check for the DC voltages there without removing
power supply.

Omar Barzanji
Cust. Eng

Technical Details

Message-ID: <9209160237.AA05220@last-call.cisco.com>

Path: arc1-ca.pugleaf.net!sparky!uunet!boulder!recnews

Show Full Headers

Complete Article Headers

Newsgroups: comp.dcom.sys.cisco
Path: arc1-ca.pugleaf.net!sparky!uunet!boulder!recnews
From: Omar Barazanji <barzanji@cisco.com>
Subject: ASM Power Supply test points
In-Reply-To: "Dean Ter Haar"'s message of 15 Sep 92 15:20:46 EST <MAILQUEUE-101.920915152018.352@legacy.calvin.edu>
Message-ID: <9209160237.AA05220@last-call.cisco.com>
Sender: news@colorado.edu
Date: 15 Sep 92 19:37:31 -0700
Lines: 15