🚀 go-pugleaf

RetroBBS NetNews Server

Inspired by RockSolid Light RIP Retro Guy

Thread View: comp.dcom.sys.cisco
2 messages
2 total messages Started by Thor Rasmussen Thu, 21 Jun 2001 19:50
[= Need Help Upgrading a Cisco 4000 Router IOS/Flash =]
#2098
Author: Thor Rasmussen
Date: Thu, 21 Jun 2001 19:50
23 lines
1809 bytes
[= Need Help Upgrading a Cisco 4000 Router IOS/Flash =]


I am a student learning about networking and routers. I have an
old Cisco 4000 router, but it has a real old IOS (Version 9.14). I
would like to upgrade this, but the router only has 2MB of flash
and 4096K/1024K bytes of memory.

The router has a daughter board which I think is where the Flash
memory is. The board has 8 AMD AM28F020 IC's on it with sockets
for 8 more. I was going to just get 8 more of these IC's, but 
doing some reasearch into the upgrade, see that the PAL chip needs
to be changed. I am not even sure if this is all that needs to be
done, or if the ROM chips need to be changed as well?

If anyone can offer any help or suggestions on what I can
do to upgrade my router's IOS  without costing a lot, I would 
very much appreciate it.

Please contact me by email at thor@mbay.net


-Thor
Re: [= Need Help Upgrading a Cisco 4000 Router IOS/Flash =]
#2099
Author: Hansang Bae
Date: Thu, 21 Jun 2001 23:18
34 lines
2888 bytes
In article <tj4jv97teguf79@corp.supernews.com>, thor@otter.mbay.net 
says...
> [= Need Help Upgrading a Cisco 4000 Router IOS/Flash =]
> I am a student learning about networking and routers. I have an
> old Cisco 4000 router, but it has a real old IOS (Version 9.14). I
> would like to upgrade this, but the router only has 2MB of flash
> and 4096K/1024K bytes of memory.
> The router has a daughter board which I think is where the Flash
> memory is. The board has 8 AMD AM28F020 IC's on it with sockets
> for 8 more. I was going to just get 8 more of these IC's, but 
> doing some reasearch into the upgrade, see that the PAL chip needs
> to be changed. I am not even sure if this is all that needs to be
> done, or if the ROM chips need to be changed as well?
> If anyone can offer any help or suggestions on what I can
> do to upgrade my router's IOS  without costing a lot, I would 
> very much appreciate it.
> Please contact me by email at thor@mbay.net


The 4MB DRAM may be a bit of a problem.  Flash doesn't matter as much 
since you can boot it via tftp (for lab purposes).  But most newer images 
require a quite of bit more than 4MB.  The good news is that DRAM is 
usually not that expensive.  Search CCO for 4000 hardware layout.  You'll 
get a lot of hits explaining where everything is.  A visit to memoryx.com 
may not hurt either.

-- 
hsb

"Somehow I imagined this experience would be more rewarding"  Calvin
********************************************************************
Due to the volume of email that I receive, I may not not be able to
reply to emails sent to my account.  Please post a followup instead.
********************************************************************
Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads