Re: Power consumption

Thread View: comp.dcom.sys.cisco

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by John Wright Sat, 15 Sep 1990 00:25

#700

Author: John Wright
Date: Sat, 15 Sep 1990 00:25

29 lines
1516 bytes

I must apologize, sometimes I find it faster to dig up answers to
questions that I don't remember the answers to off the mail archives
when I am working away from appropriate manuals. I did that today for
the AGS+ power question and I forwarded a message that had a typo in
it, that particular message had been corrected in a later message
which I did not see in the archive file. Sorry for the confusion, and
many thanks to the dozens of people who have sent me sometimes
humorous replies. ;-)

Here is this question answered by the engineer that does the
specifications/certifications for the power supplies we use:
 ---
 The actual power ratings for the AGS+ product are 7 amps @ 110 VAC
and 3.5 Amps @ 220 VAC.  These are listed in the new installation
guide.

  For UPS information, the AGS+ power supply will hold output for
approximately 20 msec. after power loss at nominal line voltage 
(derate to 6 msec. at low line - 95 VAC-).
  -------
 The 'new installation' guide mentioned is a draft document version  not yet
available.

Again, sorry for the confusion and extra net traffic this has caused.

John Wright
Customer Engineering
cisco Systems, Inc.
-------

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads