the Timer module

Thread View: comp.graphics.explorer

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by young Wed, 16 Dec 1992 20:49

#181

Author: young
Date: Wed, 16 Dec 1992 20:49

10 lines
657 bytes

I have tried to use the Timer module to output the values
0.0 through 2.0 in steps of 0.1. I've tried all combinations
to start, stop and step values, however, the increment always
seems to end up being 1.0. Does anyone understand what's
happening here?

Any help would be appreciated.

Joe Young
Internet: young@redgum.qut.edu.au

Re: the Timer module

#183

Author: Scott Ferguson
Date: Thu, 17 Dec 1992 13:58

19 lines
1415 bytes

In article <1992Dec16.154932.60878@qut.edu.au>, young@qut.edu.au writes:
|> I have tried to use the Timer module to output the values
|> 0.0 through 2.0 in steps of 0.1. I've tried all combinations
|> to start, stop and step values, however, the increment always
|> seems to end up being 1.0. Does anyone understand what's
|> happening here?
|> 

Have you made sure to hit carriage return when you typed in the
increment values? I noticed that you can type values explicitly into
the sliders, but they don't fire the module until you hit a carriage
return, so the previous value is still used by the module.

-- 
----------------------------------------------------------------------
Scott Ferguson                        Exxon Research & Engineering Co.
Project Engineer                      New Jersey
----------------------------------------------------------------------
"Always bark at a dog."

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads