🚀 go-pugleaf

In <2bv94p$hb4@aggedor.rmit.OZ.AU> s914431@minyos.xx.rmit.OZ.AU (Malcolm Herbert) writes:

>What I'd like to know is, is there a font set available for TeX that is
>the same as the standard fonts in a PS engine so that dvips doesn't have
>to include the font specification?  For example, is there Helvetica, or Times
>that TeX knows about, which is the same as the Helvetica or Times as specified
>in the guts of, say the Laserwriter?  For small, single page files, this
>change would reduce their size by as much as 70%, and more if you are
>using larger fonts, as they are bitmapped.

You can try to use standard Postscript fonts in Your document. With NFSS2
there comes a collection of files that should make this for You (psnfss).
I never tried this but I hope this work.

NFSS shoul be available on every good TeX site via ftp (or
ftp.uni-stuttgart.de).

Sven
--
Internet:                               | Yellow Mail:
                                        |     Sven Gohlke                     
   (gohlke@marie.physik.tu-berlin.de)   |     Lessingstra"se 10
                                        |     12169 Berlin

In article <2bv94p$hb4@aggedor.rmit.OZ.AU> s914431@minyos.xx.rmit.OZ.AU (Malcolm Herbert) writes:

   When one is drafting a TeX document from home and you want to look at what
   you've produced, you run it through TeX, and then through dvips to get a PS
   file at the host.  Now this is fine, except when you want to print that PS
   file on your local PostScript machine, because if you only have perhaps one
   page of document, you invariably get a file that is MUCH much bigger than
   what you started with, because TeX uses a font (computer modern?) for which
   there is no printer defined font, and so dvips must include the entire font
   definition table into your PS file.  This is a real pain when one is only at
   1200 bd.  (Yes, I know you _can_ zip things up and send them, but that avoids
   the issue!)

There are definitely several solutions better than what you are doing
at the moment.

The first to consider is sending with the .tex file, or the .dvi file
across the phone link to the machine that has the printer, and run
(tex if necessary, then) dvips on that machine.  The dvi file in
particular is a very compact representation of the document.

Next consider using standard postscript fonts.  The easiest way of
doing this is probably to use times.sty (or another font if you
prefer).  That is,

	\documentstyle[times]{article}

or some such thing.


good luck,   geoff o

--

	       geoffo@cse.unsw.edu.au
Geoff Oakley:  CS&E, UNSW, PO Box 1, Kensington, NSW 2033, Australia
	       Phone: +61 2 697 4043	Fax: +61 2 313 7987