Thread View: comp.lang.prolog
1 messages
1 total messages
Started by Claude Duguay
Wed, 30 Sep 1992 16:47
Turbo Prolog w/Pascal
Author: Claude Duguay
Date: Wed, 30 Sep 1992 16:47
Date: Wed, 30 Sep 1992 16:47
29 lines
1896 bytes
1896 bytes
My appologies if I haven't mastered the intricacies if Internet - this is my first response to a public message and I've only been set up for two days... Assuming this might get lost because of bad addresing, the message is a response to a fellow trying to link Turbo Prolog with Turbo Pascal. I provide service for Borland and the Prolog Development Center on CompuServe (PDC Prolog use to be Turbo Prolog). As I recall, the initialization code between Turbo Prolog and Turbo Pascal creates potential conflicts in certain areas so this is not a highly recommended approach. Better to use a C/Prolog link since Turbo Prolog was written on a C foundation. Jeff Dunteman, who now runs PC Techniques magazine and used to run Borland's short-lived Turbo TECHNIX magazine, published an article in Turbo TECHNIX that included code that translated Turbo Pascal TPUs to OBJ code. It may still be available through Borland or by contacting Jeff at PC Techniques. Other than using this approach, I know of no other that would solve your problem directly. The folks at PDC Atlanta are very knowledgeable and ready to help if you would like to ask if they have the code or can offer another solution. You can contact Michael Alexander at (404) 873-1366 and he will be in the best position to answer your question and provide the most suitable solution available. Claude Duguay cduguay@lcraft.ersys.edmonton.ab.ca
Thread Navigation
This is a paginated view of messages in the thread with full content displayed inline.
Messages are displayed in chronological order, with the original post highlighted in green.
Use pagination controls to navigate through all messages in large threads.
Back to All Threads