🚀 go-pugleaf

In article <427uib$qus@sun.sirius.com>, Jon Mandel <mandel@sirius.com> wrote:

> WARNING
> 
> Do not use LaCie's SilverLining software unless you fully 
> intend to reformat the drive you select.  This software will 
> write to your SCSI drive without obtaining verification from 
> you first.
> At one point we were moving things from drive to 
> drive to prepare for the burn.  We were considering 
> reformatting my drive as an HFS volume, so we launched 
> SilverLining.  We decided against reformatting after we looked 
> at the SilverLining drive configuration dialog.  We cancelled 
> out.  When I attempted to remount my drive on either system, 
> my partition information was gone.
> 
> To reiterate: SilverLining wrote to my drive *before* I 
> approved any action.  I never moved into or beyond the format 
> confirmation dialog.  Be careful.  This software is dangerous.
> 
> -Jon

Jon, I too have had problems with Silverlining.  I have version 5.6.3,
which is the very latest version, obtained by updater from LaCie's Web
site. My problem with Silverlining has to do with Virtual Memory, which,
in short, does not always work with Silverlining!!

I have a Quantum 730, running on a PowerMac 6100, which I formatted into
three equally sized Mac partitions.Immediately thereafter, I installed
from virgin system floppies a clean 7.5.1 system onto one of the
partitions.  I then booted from this partition with the clean system. 
Then, I discovered the following: (keep in mind that the system is a super
clean freshly installed version) - when VM is set to a LARGE value (in my
case about 80 MB, the system reliably crashes after the last INIT or CDEV
loads.  In some cases, if VM is set to a lower value (RAM +1MB), VM might
work or not, depending upon how many extensions are loaded!!!  The system
runs fine without VM

I later tried the same experiment with System 7.1.2, and System 7.5 with
the same results.  Also, the results were the same when I formatted with
an earlier version of Silverlining (5.6).  La Cie Tech support claimed
they were not aware of the problem in version 5.6, and referred me to
their web site, where I obtained the update to 5.6.3, which has the same
flaw.

Why do I suspect Silverlining? I do NOT experience this problem when
formatting and initializing with FWB Primer or SCSI Director!!! I have
performed this experiment at least four times, and the result is the same
each time - Silverlining prevents VM from running reliably each time,
while FWB and SCSI Director allow it to operate normally.

I would be interested to know if anyone else has experienced this
problem.  Again the pertinent data: Silverlining 5.6.3, PowerMac 6100/60,
CLEAN System 7.1.2, 7.5, or 7.5.1, Quantum 730 drive, initialized into
three partitions.  Set VM to maximum allowed (minus 1 or 2 MB for
safety).  System crashes EVERY time after INITs and CDEVs load.

Larry Knight
-- 
The L2 Company
(800) L2-PWR-PC (527-9772)
Marietta, GA, USA