🚀 go-pugleaf

I had the same problem, I think you didn't define any swap space

Roel Mathys
H.J.S Broekstra wrote in message <34B7DD83.DB0C3D49@xs4all.nl>...
>Matt Harrell schreef:
>
>> LightningBit wrote:
>> >
>> > I installed Redhat 5.0 (as a newbie) some days ago (no problems
>> there).
>> >
>> > after fooling around a bit, I decided to make a fresh installation,
>> in
>> > EXACTLY THE SAME WAY like I did before :
>> >
>> > the installation-set is on my 2nd harddrive (400 MB), (/dev/hdb1)
>> > I boot with the 2 installationdisk (boot-disk + supplemental)
>> > I create the necessar partitions on my first harddisk (1 GB) with
>> Disk Druid
>> > (/dev/hda..)
>> > it formats the swap-partition without any problems,
>> > when asked, I give the path where the redhat-distribution is located
>>
>> > (/redhat)
>> > and when he starts scanning the available packages, after a while he
>> gives
>> > messages (corrupting the installation display) like :
>> > "install exited abnormally -- recieved signal 11"
>> > "sending termination signals ... done"
>> > "sending kill signals ... done"
>> > "unmounting filesystems ..."
>> >
>> > and so on ...
>> >
>> > any comments or a solution for my problem ??
>> >
>> > thx,
>> >
>> > Lightningbit
>>
>> Check out Red Hat's "Product Errata" in their support section of their
>>
>> web site.  It gives a way around this problem for those of us who
>> experienced it.
>>
>> --
>> --
>> ----========++++++++++**********************++++++++++========-------
>>                          P120+ Cyrix 6x86, Win95 & RedHat Linux w/ CDE
>>
>> Matt Harrell             Adaptec AHA2940 Fast SCSI-2 controller
>> mharrell@voyager.net     64MB RAM, 2.1GB EIDE and 1.28GB SCSI-2 disks
>> my.voyager.net/mharrell  Sound Blaster 16 PnP, 4X CD-ROM, SyQuest
>> SyJet
>>                          Matrox Millenium II w/4MB WRAM, APC UPS-Pro
>> 280
>> ---
>> ---========++++++++++**********************++++++++++========-------
>>
>> This article was posted from <A HREF="http://www.slurp.net/">Slurp
>> Net</A>.
>
>This won't help you very much, but I had exactly the same problem while
>installing RH 4.2 (I'm not a newbie:-))) It seems to have something to
>do woth with corrupt file system or hard disk with bad sectors
>
>I'd like a solution too :-)
>
>grtx Rien Broekstra
>