🚀 go-pugleaf

Lars Bunch wrote:
> 
> Hilary Glazer <ag510@lafn.org> wrote:
> 
> : HELP !  When I try to read floppy a: or B: (do DIR ), I get this error:
> 
> : Not ready A (or B)
> : Abort, retry,fail? VOL has no label
> 
> : Abort, retry,fail?Fail on int 24
> 
> It means the computer cant't read the floppy disk.  It can happen with a
> bad disk or drive, but as you seem to be getting it with BOTH floppies,
> you might have any of the following problems...
> 
> 1) Ribbon cable has come loose.  Check at the drives and at the controler
> card.
> 
> 2) CMOS is corrupted.  As you turn on the computer you will be asked it
> you want to enter a special set up program.  The delete key or some
> variation usually gets you into it.  Make sure the CMOS values accurately
> reflect what drives you have installed.  Be careful when you change any
> values here, especially the hard drive configuration.  (Write it down
> before you make any changes so you can change it back if necessary.)
> 
> 3) YOur controller card has died.  If the card is part of the mother
> board, just find out how to disable the on board controler and buy a card
> that plugs into an ISA expansion slot.  Usually about $15 dollars.  This
> will probably control your IDE Hard drive as well. --
> 
> -------------------------------------------------------------------------------
> Lars jagatai Bunch
> jagatai@primenet.com
> Read the RANT-O-RAMA WEB PAGE at http://www.primenet.com/~jagatai/
> Rants, complaints, or just plain observations on life.
> -------------------------------------------------------------------------------
this is a test .
please reply if possible