Outbound Flow Control Problem with ZOC 2.08a and SIO

Thread View: comp.os.os2.comm

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by robking Sat, 09 Sep 1995 00:24

Author: robking
Date: Sat, 09 Sep 1995 00:24

23 lines
1411 bytes

Over the last few months, I've had a major problem whereby all my uploads
using using ZOC have crashed after about 10%-15% of the transfer.

Initially, I thought that maybe ZOC had a problem so I contatced Markus.  He 
said to make sure I have flow control enabled.  I did and still no go.
My next test was to disable SIO (v1.53).  To my surprise, this fixed the 
problem and I could happily upload again.
I also thought I'd try it with another comms program like Telix.  This worked 
too without SIO.
So, on to Ray Gwinn to tell him about my problem.  According to him, I have an
outbound flow control problem.  I've talked to a number of people since then
and Ray's diagnosis sounds right.  However, I have hardware flow control enabled
in the modem by default.

My setup is:
DX/2-66
Supra V32bis (1.71) modem
OS/2 Warp
SIO v1.53

Is there anything that I have overlooked whihc might help my situaion?

Thanks :-)

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads