🚀 go-pugleaf

Update: I finally got the updated floppy to work, but the install 
still won't load the drivers for the cdrom (I get an device driver 
error message for os2cdrom.dmd). 

I tried adding the line: 
BASEDEV=IBM1S506.ADD /A:1 /BM

to see if turning bus mastering ON for the cd-rom would help, but 
there was no change. 

again, answers would be greatly appreciated,

Kevin



On Wed, 1 Apr 1998 00:59:03, virobik@dontdoit@onr.com wrote:

> I'm having problems installing Warp 4.0 on my new WD 4 gig drive. I 
> downloaded the replacement IBM1S506.ADD and IBMIDECD.FLT drivers and 
> copied them onto Installation diskette 1 (a copy). I changed the 
> CONFIG.SYS on "D1" to SET COPYFROMFLOPPY=1 (last line of config.sys) 
> and I added the /V switch to the IBM1S506.ADD line and saved the file 
> as an OS/2 command file. 
> Booting with the original D1 allows me to go all the way through the 
> boot procedure until it asks for the Warp 4 cd and then it doesn't 
> seem to recognize the cd player. > 
> My system is a Dell P60 (CMOS is set on AUTO and seems to detect the 
> new 4 gig drive okay). I have a Promise EIDE MAX controller card that 
> runs the Mitsumi 8x cd-rom (this setup worked fine with my old HD).
> 

virobik@dontdoit@onr.com
please remove "dontdoit" when replying