Setting the SCSI ID on a Seagate ST1480N disk

Thread View: comp.periphs

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Yuval Tamir Sun, 22 Nov 1992 05:38

#1280

Author: Yuval Tamir
Date: Sun, 22 Nov 1992 05:38

10 lines
809 bytes

I am trying to set the SCSI ID of a 400MB Seagate ST1480N disk to 1.
Currently, it appears to be set to 3.  Unfortunately
I don't have the manual and I have not been able to locate the
set of DIP switches or connectors where the SCSI ID is set.


			   Yuval Tamir

Internet: tamir@cs.ucla.edu
    UUCP: ...!{uunet,ucbvax,rutgers}!cs.ucla.edu!tamir

Re: Setting the SCSI ID on a Seagate ST1480N disk

#1281

Author: Dave Olson
Date: Sun, 22 Nov 1992 21:39

12 lines
1153 bytes

In <1992Nov22.053851.1849@cs.ucla.edu> tamir@lanai.cs.ucla.edu (Yuval Tamir) writes:
| I am trying to set the SCSI ID of a 400MB Seagate ST1480N disk to 1.
| Currently, it appears to be set to 3.  Unfortunately
| I don't have the manual and I have not been able to locate the
| set of DIP switches or connectors where the SCSI ID is set.

No DIP switchs.  It is set by a set of small jumpers on the right
side of the drive near the front (as you face the drive).
--
Let no one tell me that silence gives consent,  |   Dave Olson
because whoever is silent dissents.             |   Silicon Graphics, Inc.
    Maria Isabel Barreno                        |   olson@sgi.com

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads