Decnet phase V and phase IV for X.25 (x29login for ISODE FTAM v 7.0)

Thread View: comp.protocols.iso.dev-environ

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Prakash Mishra Tue, 15 Sep 1992 07:24

#179

Author: Prakash Mishra
Date: Tue, 15 Sep 1992 07:24

32 lines
1757 bytes

Hi There!

The installation of X.25 software on DECNET V for Ultrix was not a problem. But
some thing is going awry. If we try to have a x29login to a DECNET phase IV machine it is not possible. It works otherway around without any problem.

However, if we just open a x29login from a Phase IV machine to Phase V machine
the x29login from the DECNET phase V to phase IV starts fuctioning suddenly!

We have on one machine DECNET Phase V for Ultrix and on the other DECNET Phase 
IV for VMS.

It is not possible to go around this DECNET Phase IV machine for us as this 
machine is the one connecting us to the X.25 SWITCH.

Is it possible to still communicate with x29login without having the dummy loginfrom the Phase IV to Phase V?

Without this dummy login if we try for a x29login from the ultrix machine (phaseV) the error message is following:

ERR x29login:Call not established
             Call cleared - protocol failure!


Thanks for any help in advance!!!!!

-Mishra 


-- 
|~~~~| MISHRA Prakash Chandra
|    | Centre of Academic Networking                  Tel: +43 1 58801 x-3621
|    | Technical University, Vienna             email: mishra@tuvie.can.ac.at 
|    | ----------------------------------------------------------------------

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads