🚀 go-pugleaf

In article <4271@utah-cs.UUCP>, atwell@utah-cs.UUCP (Bart L. Atwell) writes:
> What about upgrading the current ST's to accept the expansion peripherals
> that will be available on the Mega's.  It seems like there may be a lot 
> of yet to be developed peripherals that we will miss out on unless something
> is done. (like the Atari Laserprinter, for example)
> 
> Bart

The Atari laser printer will not be an expansion card which goes into
the Mega case.  It will be a device which plugs into the DMA port at
the back of all ST products.  You will be able to use both a hard disk
and a laser printer because either (A) one or the other will have a DMA
IN and a DMA OUT port (like MIDI) or (B) there will be a two-headed
DMA cable for this purpose.

Currently on the whiteboard is a floating-point board which IS an
expansion card, but that's the only thing I know of, and I think you
might be able to piggyback the chip to an existing ST without too much
trouble.

/----------------------------------------------\
| Opinions expressed above do not necessarily  |  -- Allan Pratt, Atari Corp.
| reflect those of Atari Corp. or anyone else. |     ...lll-lcc!atari!apratt
\----------------------------------------------/