Reading 1/4 tape on a MASSCOMP which was written on SGI IRIS

Thread View: comp.sys.concurrent

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Steven Fisher Sat, 24 Feb 1990 21:11

#124

Author: Steven Fisher
Date: Sat, 24 Feb 1990 21:11

14 lines
882 bytes

I have been trying to read 1/4 inch cartridge
tapes from a masscomp, written in tar format, on my
Silicon Graphics Iris.  Both use the 150MB drives from
archive.  I get a checksum error when I try to read.  I
also have tried cpio.  The Iris uses SysV Unix.  Any ideas?

steve

E-mail:    scfisher@dtoa1.dt.navy.mil


Articles to: concurrent@soma.bcm.tmc.edu or uunet!soma.bcm.tmc.edu!concurrent
Administrative stuff: concurrent-request@soma.bcm.tmc.edu
Stan Barber, Moderator

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads