🚀 go-pugleaf

[Posted and mailed]

In article <566768$4r6@nn1.fast.net>,
	kshuff@fast.net (kshuff) writes:
>  Im in need of some help, I have had a VaxStation 3100 for some time now with 
> no operating system installed, and finally managed to dig up an older version 
> of Ultrix (version 2.2) on TK50. I am having a problem booting the standalone 
> tape, the tape drive (a TZ30) comes up as MKA400, an RZ23 as DKA200, and a 
> RZ24 as DKA300. I put the tape in and give the command boot mka400, the tape 
> spins up all the way to the end, rewinds, then just sits there. I also get 
> -MKA400- on the monitor, but that is it. Am I doing something wrong? Do I need 
>  to set the boot flag to something? I know the tape drive works, I have used 
> it on a DecStation 3100 with no problems. Since I dont have a manual for the 
> VS Im not familiar with the beast at all. Any help would be appreciated.

Keith,

what sort of video driver does your 3100 have?  Ultrix doesn't work (at
least up to v4.4) with an SPX card, and on installation just appears to
hang when booting.

All may not be lost, however, as the *BSD guys are still porting to
various VAX platforms, so we may see an SPX version yet!

Of course if your 3100 is using a GPX card, then it's likely to be another
problem entirely...
Regards,

Chris.