🚀 go-pugleaf

In article <1co8iiINNdk7@agate.berkeley.edu> c60b-4gf@web-4a.berkeley.edu (MacUsers) writes:
>Posted for a friend:
>
>"How does one get signals attached to busses?  The bus tool isn't just there
>for cosmetic enhancements to designs... is it?  If so, I might have to go
>back to using (bleah) those PC-based CAD tools"
>
>Any help appreciated, thanks!
>

It's been a while since I used DesignWorks, but there a part or menu option
somewhere called something like a Bus concentrator, connector. No wait, it
is a menu item, since I remember using the command key (I don't have
Designworks anywere around me to check).

Anyway, you select this menu item, and it brings up a dialog box where
you specify the names of the signals on the bus, and it makes a single wire
connection for each name on one side, and a bus section on the other that
you connect to the bus.


..........................................................................
J. Scott Houchin			Internet: houchin@kodak.com
Eastman Kodak Co.			(716) 477-9737